Cable tie production – Guide of 2020
Cable Tie Manufacturing This article is about Cable Tie Manufacturing. After reading this, you will have a general understanding of all
Factors You Need to Consider When Choosing the Ideal Trigger Sprayer
Trigger sprayers are commonly made from polypropylene (PP). They are mounted on various designed containers that have
About the Precision Injection-molding Process Ⅱ
Part Ⅱ 3. Features and selection of precision injection machine 3.1 Features in technical parameters According
About the Precision Injection-molding Process Ⅲ
Part Ⅲ 4. Shrinkage problems in precision injection molding There are four factors that affect shrinkage:
Cable Tie Section
Cable Tie Mould – Guide of 2020
Content 1. Cable Tie Mould Design Drawing 2. Cable Tie Mould Manufacturing | Photos and Videos 3. Attention Points
Cable Tie Manufacturing Equipment
Introduction The equipment is the key factor for the success molding. In this article, we have listed all
Cable Tie Sourcing Service in China
# We are the cable tie injection molding machine manufacturer. Since 2005, we have been producing cable tie injection
Main Problems and Checking Points in Nylon Cable Tie Manufacturing
The cable tie manufacturing is one of the plastic injection molding projects, but is more difficult than the normal
The Processing Principle of Gas-assisted Injection Molding System
The gas-assisted injection molding system directly injects nitrogen into the plasticized plastic in the mold cavity through a segmented pressure control system. Then, the inside
Effects of Mold Temperature on Quality Control of Injection Molded Parts
The 5 Effects of Mold Temperature on Quality Control of Injection Molded Parts Mold temperature refers to the surface temperature of the mold
Application and Process of Gas-assisted Injection Molding
1. The principle of gas-assisted injection molding High-pressure inert gas (nitrogen) is injected into the molten plastic to form a vacuum section and push the molten
About the Light Line in the Gate Area of the Injection Molded Product
In the point gate design of the vertical part direction, a radiation system appears on the surface of the part during injection molding. It’s
The Main Plastic Properties Related to Injection Molding Processing
1. Liquidity The ability of the plastic in the molten state after being heated to fill the entire cavity under pressure is called fluidity.
About the shortcomings of injection molded parts
1. Description of shortcomings It refers to the injection molded parts that cannot meet the quality requirements of the original design and use during the injection molding