There are several main problem in the cable tie manufacturing: short shot, flashing, bubbles, gets yellow, brittle, and we will tell you why: China is the main production area for cable tie, with up to 50% of cable tie are made in China and exported to all over the world. We started developing nylon
Mold temperature controller is a small equipment which used for heating the connected mold to obtain the correct operating temperature in a minimal or specified time and maintain the set temperature by heating or cooling. There two types of mold temperature controller on the market, oil type and water type. Heat transfer medium of mold temperature
In 2018, Several leading manufacturers of PA 66 suffered from force majeure, resulting in insufficient supply of PA66 raw materials, contradiction between supply and demand, and soaring prices. PAThe common manners are: 1. Replace imported PA66 with domestic PA66 2. Increase the proportion of recycled materials 3. Increase the proportion of PA6 4. Adoption recycling
How does the injection molding machine accurately and efficiently control the temperature of the barrel?
1.The temperature of injection molding machine barrel controlled by the microcomputer, select the appropriate algorithm to control the heating band outside the barrel of the injection machine. Ensure that the working temperature of each section of the barrel can be kept within the set range according to the technical requirements. For precise plastic injection
This post gives you some advice on reducing the injection molding cost. Production workshop The layout of production workshop focuses on two aspects: meeting the production requirements, optimizing the layout according to the production process, and meeting the requirements for flexible energy use under specific production conditions. 1). The power
The connecting part of the robot is mainly fixed by screws, which may be loosened due to long-term vibration, causing the failure of robot or some connecting parts to break. On the other hand, robot vibration may cause the wire connector or relay to loosen, resulting in poor circuit contact, the robot may be out
Advantage 1.Shorten cycle time The molding cycle is shortened. Because there is no restriction on the cooling time of the sprue system, the parts can be ejected in time after curing. Many thin-walled parts produced with hot runner molds have a molding cycle of less than 5 seconds. 2.Save plastic material